Lanair Products LLC
Capital, Janesville, WI

Lanair Products LLC Reviews

3.3 stars based on 16 reviews

Featured Comments:

• J

  John Arkesteyn

  1.0

  After spending good money on this MX200 unit, its been nothing but issues. I've had to work on it every year and spend money throwing parts at it for minimal usage. The worst part is NO ONE WORKS ON THESE THINGS AND ALL REPAIR SHOPS SAY THEY ARE FIRE HAZARDS! I am not your typical run it until it dies guy. We have kept it clean including filters, burn box, etc. we only put straight used motor oil in the tank and even keep separate drain canisters so that our oil never gets mixed with pollutants. Yet here we are, another year with this piece of junk not working . Wish I had never bought it. If you are thinking about going this route, DON'T!! save your time and frustration and buy from someone else. Lanair products don't last, don't work, and there is literally NO ONE that will work on it. The only thing I can see they take pride in that I can see is the fact that they will tell you there is no one to work on their product, once you buy it, its yours and you better learn to work on it. Everyone you call for service will tell you exactly what I will now, best thing to do is scrap it and buy another brand to replace it.

• C

  CHRIS NEAL

  1.0

  We purchased a lanair oil heater 2 years back. while we where having the machine serviced the technician noticed a crack in the heat chamber. We called lanair and talked with Dane Arpiainen. he asked if the cracked was in the rear on the bricked side because if that was the case it was over fired and would not be covered under the warranty. we told him no it is on the front side towards the door at the time he told us we must have an exhaust/vent problem and that is not covered as well. after taking a bunch of pictures Dan called me back. Dan said his boss kevin knox said it is not covered because the pictures indicate to him that is was over fired. They did offer to pay halve of the repair . I believe from the conversations I have had with this company your lucky to get half off something warrantied. By the way I did not take them up on the halve deal as I would rather buy a new machine from a company i can trust. I didn't mention that after the first three months of use the igniter went out. we purchased a new one without contacting lanair about possible warranty. but when the chamber cracked we gave them a call.

• J

  Jack Nuts

  3.0

  they produce a very top quality product but the overall price doesn't justify in my opinion. a waste oil boiler is 10k with a life span of 20 years. a lp fuel boiler with same btu is 3200. with fuel cost over 20 yeard costs 12k. so in my opinion that 2k difference isn't justified.

More reviews (5)